Instructions

1. Die-cut the mat board and the patterned paper at the same time, making sure the patterned paper is directly against the die and the mat board is on top of the paper.
2. Fold each scored section of the mat board before adhering the paper on top.
3. After adhered together, fold each section, which will break the paper apart at the corners to make them all individual pieces.  If the paper isn't cut through, use a craft knife to cut apart.
4. Adhere a magnet to the back side of the flap.
5. Adhere second magnet (or correct polarity) to the inside of the box, making sure the magnets align.
6. Add two brads to the bottom of the box (used as decoration, not to secure box closed) and then seal box closed by using two brads on the top set of holes.
7. Adhere patterned paper ribbon slide to mat board.
8. Weave the ribbon slide onto the ribbon and adhere both ends of ribbon to the inside of the box.
9. Adhere epoxy sticker to front flap.